| Here our just some of the products we offer! |
Along with the products that we build in house, we are also proud users and dealers for other fine products by companies like:
Strange Engineering
Phenix Industries AN fittings
SX-Performance fuel systems
Bassani Exhaust
Chris Alston Chassisworks
Al's Liner
As well as others, if you need anything for your racecar, street car, or hot rod, just give us a call.
|
Adjustable seat mounts for Kirkey Racing Seats
Allows for up, down, front, back and angle adjustment
Made from .090 steel
Simple weld in installation in any vehicle
$40.00
Note:
On certain vehicles with a very deep rear seat foot well, we can make the lower bracket extra long in the rear to accommodate the depth. We can also modify them as you need. Minimum $5 additional charge per seat for changes.
| Lower mount is tall for trimming purposes. To install, simply bolt the brackets to the seat. Position the seat in the car in the desired location and cut slits (we usually put 2 cutting discs on an angle grinder) in the floor allowing the lower bracket to slide through and mark the floor height on the bracket for trimming purposes. After proper trimming and positioning is achieved, tack weld the brackets to floor and remove the seat for final welding on both sides. This provides a very sturdy and secure seat mount. In full chassis cars we generally trim and weld the lower mount to a tube.
|
GCR Anti-Roll Bar for Mustang
Chromoly construction
Pre welded in our steel fixture. This is not a kit you will have to weld together yourself.
This unit does NOT permit ANY body roll
Allowing you to have straighter and more consistent launches every time
Welds between the factory frame rails
1" 6061T-6 Billet Aluminum link arms and 7/16" Chromoly Rod Ends
$300.00
|
GCR Nitrous Bottle Heater This utilizes the heated water bath method, which is much more reliable than hot air systems out there. This system truly heat-soaks the bottle, warming the bottle and the liquid inside. This method keeps heat and bottle pressure longer while waiting in the staging lanes on those cool spring and fall nights. With the integrated adjustable thermostat, you don't have to worry about overheating the bottles. The bottles will maintain a steady temperature and pressure, wether it's been 15 minutes or 3 hours, your bottles are ready when you are.
The box features an adjustable thermostat to maintain steady temperature
Runs on 110 volt power
It is 100% powder coated
Completely Tig welded
It has a tray in the bottom with circulation holes to help the heat spread evenly
Carrying handle
Rubber bumpers on the bottom so it does not slide around
petcock drain (can be easily converted for trailer mount and drain)
Holds 2 nitrous bottles and approx. 5 gallons of water
|
 |
| 1st Gen F-body connectors |
|
|
 |
| 1st Gen F-body connectors |
|
|
 |
| 1st Gen F-body connectors |
|
|
1st Generation F-Body sub-frame connectors
*Profiled to hug the shape of the floorpan
*Chromoly tubular constuction
*Tig welded
*Bolt-in or Weld-in
|
Custom signs or emblems to accent your car, your garage, or your basement!
*any design possible
*virtually any material imaginable
(Call or email for a quote today)
|
|
